Unique opportunity to lease this HUGE detached 2400 sq/ft workshop (40×60) on a poured concrete slab. It was built with 22 ft Center height ceilings, 16 ft eves and an insulated metal roofing system. There are 3 bay doors, two 14 ft in the front and one 12 ft in the rear. Each is also complete with poured parking pads outside of the bays as you enter. Inside is complete with an 8000 lb. lift with and an added Gantry complete with 2000 lb. hoist and chain, and air compressor to be used by the tenant if so desired. Please see additional agreement/addendum regarding use of lift. The shop has multiple 220v outlets on almost every wall. Its 2 phase for welders etc. and a 3-phase inverter can be easily added to run larger draw equipment such as Mills, Lathes, to name a couple. Also included are a few tables, one is a large steel table. The shop has a 10X40 loft, small office, and ½ bath. There is also an 8×25 enclosure with a large steel swing out door on the outside and the shop can be entered by a small entry door inside. There is a poured concrete air compressor pad in the rear as well. For additional covered parking, on the side of the shop is a large lean-to carport parking for boat, trailer, small RV, etc. Shop/Garage tenant will make considerable efforts to not interfere with single family home’s tenants and their privacy.